Mind-2-Matter

You may remember Gnorman from earlier this year.

This was my free sculpture for my figure modeling class during the Spring 2013 semester at AAU.

This may be the piece of work that I am the most proud of ever. EVER. (and I’ve made a lot of art in the last 30 years). Needless to say I was most saddened when I was too busy to properly finish Gnorman and have him fired (I went straight from work/school to wedding prep/work and he dried out!).

I had been crossing my fingers that we could get him scanned before he was a total loss since June/July. Our method of scanning wasn’t the easiest but Justin and I worked through a variety of methods using Kinect cameras for another project and I figured that we would, at some point, rig that set up again.

Well, we didn’t have to.


The Gnomes (thanks to the Elder Gnome) have acquired the Sense 3D Scanner.

A few minutes time and we had a model to print. I was so excited I could barely contain myself last night! The original Gnorman is 8″ W x 13″ D x 24″ H. New Gnorman is about 1″ W x 1.5″ D x 4″ H!

So exciting!  
And it was just in time. Gnorman’s ear fell off after we finished scan!

Leave a Reply

\